Arduino Mega 2560 Rev3 Mainboard with USB Cable - ATmega2560-16AU - BluePrint
- Dijual oleh
- Grosir Elektronik 100% Verified Seller
- Berat Pengiriman
- 0.1 kg
- 1 Bulan
Nikmati belanja murah ditambah diskon spesial
Pesanan diproses sesaat setelah pembayaran lunas
Semua barang kami terjamin mutu dan kualitasnya
Kami selalu memberikan harga terbaik tanpa mengurangi mutu
People also Bought
Arduino L293D Driver Motor Shield - BlueRp. 29.100,-
Programmable NFC Tag Sticker (1 Sticker)Rp. 6.500,-
Raspberry Pi 2 GPIO Breadboard 830 Point…Rp. 22.400,-
Acrylic Case for Raspberry Pi 3 Model B+…Rp. 18.400,-
Motor RC MG995 Metal untuk Futaba / Hitec…Rp. 48.300,-
V3 Wireless module NodeMcu 4M Bytes Lua…Rp. 44.400,-
Overview of Arduino Mega 2560 Rev3 Mainboard with USB Cable - ATmega2560-16AU
The Mega 2560 is an update to the Mega, which it replaces.
The Mega2560 differs from all preceding boards in that it does not use the FTDI USB-to-serial driver chip. Instead, it features the CH340 programmed as a USB-to-serial converter.
Revision 2 of the Mega2560 board has a resistor pulling the 8U2 HWB line to ground, making it easier to put into DFU mode.
Revision 3 of the board has the following new features:
1.0 pinout: added SDA and SCL pins that are near to the AREF pin and two other new pins placed near to the RESET pin, the IOREF that allow the shields to adapt to the voltage provided from the board. In future, shields will be compatible both with the board that use the AVR, which operate with 5V and with the Due that operate with 3.3V. The second one is a not connected pin, that is reserved for future purposes.
Stronger RESET circuit.
Atmega 16U2 replace the 8U
- Microcontroller CH340
- Operating Voltage 5V
- Input Voltage (recommended) 7-12V
- Input Voltage (limits) 6-20V
- Digital I/O Pins 54 (of which 15 provide PWM output)
- Analog Input Pins 16
- DC Current per I/O Pin 40 mA
- DC Current for 3.3V Pin 50 mA
- Flash Memory 256 KB of which 8 KB used by bootloader
- SRAM 8 KB
- EEPROM 4 KB
- Clock Speed 1 6 MHz